ASAB DDP42 Replacement Parts #25 - Foot Support Bar

Part Code: ASAB-SDDP42-25

Introducing the ASAB DDP42 Foot Support Bar — a structural support component designed to reinforce and stabilise the base/foot assembly on ASAB DDP42 double diaphragm pumps. Built to handle vibration, movement, and job-site knocks, this bar helps keep the pump sitting square, supports consistent mounting alignment, and reduces stress on the feet and base hardware during operation and transport.

A bent, cracked, or missing support bar can lead to wobble/rocking, increased vibration, uneven loading on foot pads, and mounting bolts loosening over time — especially on hard surfaces or skid-mounted setups. Replacing the foot support bar is a simple way to restore stability, tidy up the base assembly, and help prevent fatigue damage to surrounding mounts and brackets.

Whether you’re refurbing a pump base, repairing impact damage, or tightening up a unit that’s been “walking” around the floor, the ASAB-SDDP42-25 is a workshop-ready solution for a steadier, longer-lasting DDP42 setup.

Key Benefits

• Direct replacement foot support bar for ASAB DDP42

• Reinforces the pump base to improve stability and alignment

• Helps reduce vibration and rocking by supporting the foot assembly

• Prevents uneven load on foot pads and base hardware

• Ideal replacement for bars that are bent, cracked, or missing

• Supports tidier mounting on skids, frames, and workshop floors

• Built for commercial workshop and job-site use

What’s Included

• DDP42 Foot Support Bar — ASAB-SDDP42-25

Safety Check

• Isolate and depressurise first: Shut off air supply, bleed the airline fully, and confirm the pump is not cycling before working around the base.

• Support the pump safely: If lifting/tilting, use correct manual handling or lifting gear—don’t trap fingers under the frame.

• Check mounting hardware: Inspect bolts, brackets, and foot pads while you’re there—loose mounts amplify vibration.

• Align before tightening: Seat the bar correctly so the pump sits level and doesn’t preload the feet.

• Test at low pressure: Run briefly at low air pressure to confirm stability before returning to normal operation.

ASAB – Engineered for Performance, Built to Last.