ASAB Filters - Single Layer High Pressure Filter Strainer Element (200 mesh)

Part Code: ASAB-HPF730067-200S

Introducing the ASAB Single Layer High Pressure Filter Strainer Element (200 Mesh) — a fine-filtration element designed to keep high-pressure spraying systems running clean and consistent by capturing very small particles before they reach the gun, tip, and other downstream components. A clean strainer element is one of the easiest ways to reduce nuisance blockages, stabilise spray pattern, and protect high-pressure gear from contamination-related wear.

With a 200 mesh rating, this element is suited to applications where you need finer filtration for cleaner finishes and reduced tip plugging — particularly with well-filtered materials and lighter viscosity coatings. It’s ideal for routine servicing, filter rebuilds, or any time your existing element is restricted, damaged, or letting debris through.

Whether you’re doing preventative maintenance or chasing cleaner spraying with fewer stoppages, the ASAB-HPF730067-200S is a workshop-ready solution for dependable high-pressure filtration.

Key Benefits

• 200 mesh filtration to capture very fine debris before it hits the gun/tip

• Helps reduce tip blockages and spray pattern disruption

• Supports cleaner finish quality by limiting contamination in the line

• Protects high-pressure components from debris-related wear

• Helps maintain more consistent flow and stable pressure delivery

• Single layer design for straightforward fitment and maintenance

• Built for commercial workshop and job-site use

What’s Included

• ASAB Single Layer High Pressure Filter Strainer Element (200 mesh) — ASAB-HPF730067-200S

Safety Check

• Depressurise fully before service: Prime/relief on, trigger into a waste bucket, and confirm pressure is at zero before opening any filter housing.

• Injection hazard: Never check leaks with your hand — use cardboard/rag and keep clear of pressurised joints.

• Check element condition: Replace if the mesh is torn, crushed, or deformed — damaged screens let debris through and block tips.

• Don’t over-restrict the system: 200 mesh can restrict flow on heavier coatings—match mesh to material type and required flow.

• Clean sealing faces: Dirt on O-rings/seats can cause leaks after reassembly.

• Pressure test gradually: Reassemble, start at low pressure, check for leaks, then increase slowly to operating pressure.

ASAB – Engineered for Performance, Built to Last.