ASAB Filters - Single Layer High Pressure Filter/Strainer Element (30 mesh)

Part Code: ASAB-HPF730067-30S

Introducing the ASAB Single Layer High Pressure Filter/Strainer Element (30 Mesh) — a coarse filtration element designed to protect your high-pressure spraying system while maximising flow for heavier materials and higher-volume applications. The 30 mesh screen is ideal for catching larger contamination (chips, flakes, skin, grit) before it reaches your gun/tip, without over-restricting the line and starving the pump.

With a 30 mesh rating, this element is a great choice when you’re running thicker coatings, higher flow rates, or working in environments where debris is more likely — while still protecting downstream components from the big stuff that causes blockages and wear. It’s also a smart service item to replace whenever your current screen is damaged, clogged, or starting to deform.

Whether you’re doing preventative maintenance or setting up your filter for higher-flow work, the ASAB-HPF730067-30S is a workshop-ready solution for dependable high-pressure filtration.

Key Benefits

• 30 mesh coarse filtration to catch larger debris before it hits the gun/tip

• High-flow friendly — helps reduce restriction compared to finer mesh elements

• Helps prevent nuisance blockages from flakes/skins/chips in the line

• Protects high-pressure components from contamination-related wear

• Supports more consistent flow and stable pressure delivery under load

• Single layer design for straightforward fitment and maintenance

• Built for commercial workshop and job-site use

What’s Included

• ASAB Single Layer High Pressure Filter Strainer Element (30 mesh) — ASAB-HPF730067-30S

Safety Check

• Depressurise fully before service: Prime/relief on, trigger into a waste bucket, and confirm pressure is at zero before opening any filter housing.

• Injection hazard: Never check leaks with your hand — use cardboard/rag and keep clear of pressurised joints.

• Check element condition: Replace if the mesh is torn, crushed, or deformed — damaged screens let debris through and block tips.

• Match mesh to the job: 30 mesh won’t stop fine contaminants — if you need a cleaner finish, step up to a finer element (once material and flow allow).

• Clean sealing faces: Dirt on O-rings/seats can cause leaks after reassembly.

• Pressure test gradually: Reassemble, start at low pressure, check for leaks, then increase slowly to operating pressure.

ASAB – Engineered for Performance, Built to Last.