ASAB Filters - Single Layer High Pressure Filter/Strainer Element (60 mesh)

Part Code: ASAB-HPF730067-60S

Introducing the ASAB Single Layer High Pressure Filter/Strainer Element (60 Mesh) — a mid-range filtration element designed to keep your high-pressure spray system running clean and consistent without choking flow. 60 mesh is a great all-rounder: fine enough to catch a lot of the nuisance debris that blocks tips, but open enough to maintain decent flow for many common coatings.

This strainer element helps protect downstream components like guns, tips, hoses, and valves by catching contamination before it becomes a blockage or causes wear. It’s ideal for routine servicing, filter rebuilds, or as a go-to mesh when you want a balance between protection and throughput.

Whether you’re chasing fewer tip blockages, steadier spray pattern, or just doing preventative maintenance properly, the ASAB-HPF730067-60S is a workshop-ready solution for dependable high-pressure filtration.

Key Benefits

• 60 mesh filtration for a solid balance of debris control and flow

• Helps reduce tip blockages and spray pattern disruption

• Protects high-pressure components from contamination-related wear

• Supports more consistent flow and stable pressure delivery under load

• Ideal for routine servicing and filter rebuilds

• Single layer design for straightforward fitment and maintenance

• Built for commercial workshop and job-site use

What’s Included

• ASAB Single Layer High Pressure Filter/Strainer Element (60 mesh) — ASAB-HPF730067-60S

Safety Check

• Depressurise fully before service: Prime/relief on, trigger into a waste bucket, and confirm pressure is at zero before opening any filter housing.

• Injection hazard: Never check leaks with your hand — use cardboard/rag and keep clear of pressurised joints.

• Check element condition: Replace if the mesh is torn, crushed, or deformed — damaged screens let debris through and block tips.

• Match mesh to the job: If you’re running thick product and see starvation/pressure drop, step down to a coarser mesh; if chasing finer finish, step up finer (as material allows).

• Clean sealing faces: Dirt on O-rings/seats can cause leaks after reassembly.

• Pressure test gradually: Reassemble, start at low pressure, check for leaks, then increase slowly to operating pressure.

ASAB – Engineered for Performance, Built to Last.