ASAB Filters - Single Layer Strainer Element (100 mesh)

Part Code: ASAB-HPF730067-100S

Introducing the ASAB Single Mesh High Pressure Filter Strainer Element (100 Mesh) — a precision filter element designed to keep your high-pressure spraying system running clean and consistent by catching fine debris before it reaches the gun, tip, and downstream components. A fresh strainer element is one of the simplest ways to reduce tip blockages, stabilise spray pattern, and protect high-pressure gear from contamination-related wear.

With a 100 mesh rating, this element is suited to finer filtration where you want to trap smaller particles that can cause nuisance blockages and finish defects. It’s ideal for regular servicing, system rebuilds, or any time your filter is showing signs of restriction, damage, or contamination.

Whether you’re doing preventative maintenance or chasing cleaner spraying with fewer stoppages, the ASAB-HPF730067-100S is a workshop-ready solution for dependable high-pressure filtration.

Key Benefits

• 100 mesh filtration to capture fine debris before it hits the gun/tip

• Helps reduce tip blockages and spray pattern disruption

• Protects high-pressure components from contamination-related wear

• Supports more consistent flow and stable pressure delivery

• Ideal for routine servicing and filter rebuilds

• Single mesh design for straightforward fitment and maintenance

• Built for commercial workshop and job-site use

What’s Included

• ASAB Single Mesh High Pressure Filter Strainer Element (100 mesh) — ASAB-HPF730067-100S

Safety Check

• Depressurise fully before service: Prime/relief on, trigger into a waste bucket, and confirm pressure is at zero before opening any filter housing.

• Injection hazard: Never check leaks with your hand — use cardboard/rag and keep clear of pressurised joints.

• Check element condition: Replace if the mesh is torn, crushed, or deformed — damaged screens let debris through and block tips.

• Clean sealing faces: Dirt on O-rings/seats can cause leaks after reassembly.

• Install the correct mesh: Too fine a mesh can restrict flow on heavier materials—match mesh to coating and tip size.

• Pressure test gradually: Reassemble, start at low pressure, check for leaks, then increase slowly to operating pressure.

ASAB – Engineered for Performance, Built to Last.